Ski touring boots – stepping in made easy

Ski touring boots

stepping in made easy

The correct way to get into a ski touring boot is slightly different depending on the model.

In general: The liner should already be in the shell and the hiking mechanism should be open. All lacing systems and buckles are open to the maximum. It is recommended to wear ski socks with reinforcements at the heel and shin to protect the critical friction points. Make sure that the socks fit without creases. After entry, close the inner boot with Velcro or a lacing system. Then the boot shell must be closed. To avoid slipping and thus blisters, close the forefoot area with moderate tension. In the upper part of the shaft, leave as much “air” and freedom of movement as possible during the ascent. Therefore, only hook the buckles in, but do not tighten them. If available, close the upper Velcro strap at maximum width. Finally, pull the gaiter of the pants over the shaft and the tour can begin. You can find detailed instructions on how to get started with the Dalbello Quantum ski touring boot in the following video.


Mit dem Laden des Videos akzeptieren Sie die Datenschutzerklärung von YouTube.
Mehr erfahren

Video laden

Related articles
everything you always wanted to know about gear
how to
Contributions from the category Tips & Tricks

Stepping into bindings in deep snow

With a few tricks, it’s really easy to step into the bindings after removing the skins: in soft snow, insert the tail of both skis into the snow so that …

Read more

Packing safety equipment in your backpack for easy access

Backpack There is certain equipment that you should have with you on every ski tour This includes an avalanche transceiver, an avalanche probe and a shovel. It is also useful …

Read more
others are also interested in:
Are you well prepared?